Summa S class 2 series - Page 8

S CLASS™ 2 cutter User’s Manual
Table of contents IV
5 Maintenance and Cleaning ........................................................................... 5-1
5.1 Introduction......................................................................................................... 5-1
5.1.1 Cleaning the drive system ................................................................................................... 5-1
5.1.2 Cleaning the media sensors ................................................................................................ 5-1
5.1.3 Cleaning the Y-Guide Rail .................................................................................................... 5-2
5.1.4 Cleaning the nose piece (tangential machine only) ................................................... 5-2
5.1.5 Cleaning the OPOS system .................................................................................................. 5-3
5.1.6 Changing the fuse .................................................................................................................. 5-4
6 Specs and General Information .................................................................... 6-1
6.1 Introduction......................................................................................................... 6-1
6.1.1 Product features ...................................................................................................................... 6-1
6.2 Specifications ...................................................................................................... 6-3
6.2.1 Cutter ........................................................................................................................................... 6-3
6.2.2 Media ........................................................................................................................................... 6-3
6.2.3 Knife, pen and pouncing tool ............................................................................................. 6-4
6.2.4 Interface...................................................................................................................................... 6-5
6.2.5 Firmware .................................................................................................................................... 6-5
6.2.6 Performance ............................................................................................................................. 6-6
6.2.7 Certifications ............................................................................................................................. 6-6
6.2.8 Environmental .......................................................................................................................... 6-7
6.2.9 Electrical ..................................................................................................................................... 6-7
6.3 Cutter accessories and consumables ................................................................. 6-8