Summa S ONE - Page 6

S One User’s Manual
Table of contents II
2.2.1 Setting the tool type .............................................................................................. 2-3
2.2.2 Changing the tool pressure ................................................................................... 2-4
2.2.3 Changing the drag knife offset .............................................................................. 2-5
2.6.1 Procedure ............................................................................................................ 2-11
2.6.2 Practical tips ........................................................................................................ 2-14
2.6.2.1 Physical knife depth ..................................................................................... 2-14
2.6.2.2 Values of the FlexCut parameters ............................................................... 2-15
2.6.2.3 Material without a backing .......................................................................... 2-17
3 OPOS ..........................................................................................................3-1
3.2.1 Printing the graphic ............................................................................................... 3-2
3.2.2 Different OPOS alignment methods....................................................................... 3-3
3.2.3 Processing long jobs ............................................................................................. 3-4
3.3.1 OPOS origin ........................................................................................................... 3-6
3.3.1.1 In combination with OPOS X mode ................................................................ 3-6
3.3.1.2 In combination with OPOS XY, OPOS XY2 or OPOS Xtra mode ..................... 3-6
3.3.1.3 In combination with OPOS Barcode .............................................................. 3-7
3.3.2 Cutting multiple copies of a graphic on the same roll .......................................... 3-8
3.3.3 Cutting the same graphic on multiple media sheets .......................................... 3-10
3.3.4 OPOS Barcode ..................................................................................................... 3-12
3.3.4.1 Introduction ................................................................................................. 3-12
3.3.4.2 Initiating the barcode procedure ................................................................ 3-13
3.4.1 OPOS calibration.................................................................................................. 3-14
3.4.2 Media calibration ................................................................................................. 3-15
4 Detailed operation .................................................................................. 4-1
4.2.1 Knife/Pen* pressure .............................................................................................. 4-1
4.2.2 Knife/Pen* offset ................................................................................................... 4-1
4.2.3 FlexCut ................................................................................................................... 4-2
4.2.4 Tool ........................................................................................................................ 4-2
4.2.5 Submenus .............................................................................................................. 4-2
4.3.1 Confidence test ..................................................................................................... 4-3
4.3.2 Load ....................................................................................................................... 4-3
4.3.3 Load extended ....................................................................................................... 4-3
4.3.4 Replot..................................................................................................................... 4-3
4.3.5 Reset ...................................................................................................................... 4-3
4.4.1 Velocity .................................................................................................................. 4-4
4.4.2 Overcut .................................................................................................................. 4-4
4.4.3 OptiCut ................................................................................................................... 4-4