Operator Entries for Fibre Channel
96122 • Revision: F Chapter 6 SCSI Commands 89
Operator Entries for Fibre Channel
The Fibre Channel interface requires configuration of the library’s Port 0 address.
You may configure the library for soft or hard addressing of this port.
If you configure the library for hard addressing, you may input the Port 0 address
yourself through the library’s operator panel or through the library’s StreamLine
Library Console (SLC) if used. Allowable loop addresses are 000d to 125d.
Note – Before you input a Port 0 address, you must first set the library’s Fibre
Channel hard address option to enabled.
If you configure the library for soft addressing, you are allowing the Fibre Channel
software to configure the Port 0 address. Addresses are assigned in ascending
order. For this addressing approach, you must disable the Fibre Channel hard
address option.
Note – The default for the hard address option is disabled. See the library operator’s
guide for additional instructions on setting these values.
To Next Page
Loading...
Need help?
General
