Library and Tape Drive Configurations
250 SL500: Interface Reference Manual • July 2008 Revision: F • 96122
Library and Tape Drive Configurations
Note – You might not be able to use the StreamLine Library Console to configure
the library and tape drives. Use the CLI commands in the following tables or type
help lib or help drive for a list of the commands.
TABLE B-1
CLI Commands for Library Configuration
allowpartitions <print|on|off> Enables/disables the partitioning feature.
Note: You must have an advsrv password for this
command.
autoclean print (firmware level 1022) Shows the library's current setting
autoclean <on|off>
(firmware level 1022)
Sets the auto clean option on or off. On causes tape drives
to be automatically cleaned when needed. Off disables
automatic cleaning. If the host software is handling tape
drive cleaning, set the option to off.
cap <module#> <io|storage> Configures the specific module’s CAP as input/output or
storage
cartridge print Shows the location, volume serial number, and media type
for all cartridges
cartridge print reserved
(firmware level 1022)
Shows the location, volume serial number, and media type
for reserved cartridges
clearcartcount print
(firmware level 1022)
Shows the library's current list of cleaning cartridges and
cleaning counts
clearcartcount <label> count
(firmware level 1022)
Sets the number of times a particular cleaning cartridge
can be used. The cartridge must be in the cleaning list. The
cleaning list is not complete until the audit is finished.
cleanwarnthreshold print
(firmware level 1022)
Shows the library's current warning threshold count for
cleaning cartridges
cleanwarnthreshold <count> <drivetype>
(firmware level 1022)
Sets a warning threshold count for the number of cleans a
cartridge can perform for a given tape drive type before a
warning is issued. <drivetype> is “lto” or “dlt”. If the
value is set to 0, no warning is issued.
lib getconfig Shows the library configuration
To Next Page
Loading...
Need help?
General
