EasyManuals Logo

Sun Microsystems StorageTek SL500 Reference Manual

Sun Microsystems StorageTek SL500
296 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #76 background imageLoading...
Page #76 background image
FC-AL Features
48 SL500: Interface Reference Manual July 2008 Revision: F 96122
Loop Initialization Soft Assigned
StorageTek libraries support the process of Loop Initialization Soft Assigned (LISA)
addresses. This process is supported when the hard-assigned address has been
used by a different device or the hard-assigned addressing is disabled.
Failure to Obtain a Loop Address
If an NL_Port is unable to obtain an address (fabric assigned, previously assigned,
hard assigned, or soft assigned), it goes into a non-participating mode and
immediately implicitly logs out all NL_Ports.
If an NL_Port experiences a power-on reset or recognizes a LIP(AL_PD,AL_PS), it
is not required to retain a previously acquired address to use during the next loop
initialization.
Open State/Loop Initialization
The open initializing (OPEN-INIT) state performs the process of loop initialization.
When ports are in this state, initialization frames are transmitted and received to
identify the temporary loop master and to assign AL_PA values. Entering this state
assumes the loop is operational and sets the Available BB_Credit equal to zero. (See
“Login_BB_Credit Equals Zero” on page 51.)
Related Processes
The following processes might occur during initialization.
Loop Initialization Select Master
StorageTek libraries support the process of selecting a Loop Initialization Select
Master (LISM) by using the device with the lowest port address.
Note – If an FL_Port (fabric loop attachment) is present, it assumes the role of
Loop Initialization Select Master.
Loop Initialization Report Position
StorageTek libraries support the mapping process to build a map of the AL_PA
values according to the library’s position on the loop. The temporary loop master
begins the procedure to create a Loop Initialization Report (LIRP).
This initialization report and map is done by using a 1-word frame identifier with
an offset value of one (1). As the frame is transmitted around the loop, the next
NL_Port increments the offset by a value of one and stores the information in the
AL_PA map.

Table of Contents

Other manuals for Sun Microsystems StorageTek SL500

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sun Microsystems StorageTek SL500 and is the answer not in the manual?

Sun Microsystems StorageTek SL500 Specifications

General IconGeneral
BrandSun Microsystems
ModelStorageTek SL500
CategoryStorage
LanguageEnglish

Related product manuals