Mode Select (10)
96122 • Revision: F Chapter 6 SCSI Commands 117
Mode Select (10) Data
The initiator must provide mode parameter data in a parameter list including:
■ “Mode Select (10) Parameter Header” on page 117
■ “Fibre Channel Logical Unit Page” on page 118
■ “Low Voltage Differential SCSI Logical Unit Page” on page 119
■ “Fibre Channel Port Control Page” on page 120
■ “Low Voltage Differential SCSI Port Control Page” on page 121
■ “Informational Exceptions TapeAlert Page” on page 122 or
■ “Element Address Assignment Mode Page” on page 124
Mode Select (10) Parameter Header
The library returns a 8-byte Mode Select parameter header as follows:
Note – The header definitions for the library must be all 00h.
Parameter List Length ■ 00h = No data transferred
A value of 00h is not considered an error.
Any other value is considered an error and is not supported.
■ 14h = Mode Parameter Header and Informational Exceptions TapeAlert
Mode Page are transferred
■ 1Ch = Mode Parameter Header and Element Address Assignment Page are
transferred
■ 10h = Mode Parameter Header and Logical Unit Page are transferred
■ 10h = Mode Parameter Header and Port Control Page are transferred
TABLE 6-28 Mode Select Parameter Header
Byte
Bit
76543210
0 Reserved (00h)
1 Reserved (00h)
2 Reserved (00h)
3 Reserved (00h)
4 Reserved (00h)
5 Reserved (00h)
6 Reserved (00h)
7 Reserved (00h)
To Next Page
Loading...
Need help?
General
