Sun Microsystems StorageTek SL500 Reference Manual

Report LUNS
206 SL500: Interface Reference Manual • July 2008 Revision: F • 96122
Report LUNS
The Report LUNS command (A0h) returns to the initiator the known LUNs to
which the initiator can send commands.
TABLE 6-80 Report LUNs Command
Byte
Bit
76543210
0Operation Code (A0h)
1Ignored Reserved (0h)
2Select Report
3
to
5
Reserved (0h)
6
to
9
(MSB)
Allocation Length
(LSB)
10 Reserved (00h)
11 Control Byte (00h)
Report LUNs command Definitions:
Select Report This field specifies the type of logical unit addresses that shall be reported.
■ 00h = LUN addresses reported shall be limited to the following addressing:
■ LUN addressing method;
■ Peripheral device addressing method; and
■ Flat space addressing method.
■ 02h = All LUNS accessible to the initiator for this port are accessible
Allocation Length This field specifies the number of bytes that the initiator has allocated for data
to be returned from the Report LUNs command.
The Allocation must be at least 16 bytes.
If it is less, a check condition is returned with the sense key set to illegal request
and the additional sense data set to invalid field in the command descriptor
block (CDB).

Sun Microsystems StorageTek SL500 Specifications

General

Brand	Sun Microsystems
Model	StorageTek SL500
Category	Storage
Language	English