Library and Tape Drive Configurations
96122 • Revision: F Appendix B Partitioning Overview 251
lib setconfig Sets the specified library's Fibre Channel or SCSI
configuration
orientlabel <host|oppanel>
<all|left8|left7|left6|right6|right7|right8>
<partition>
See Note at Right
Sets the host (Sun) orientlabel parameter. This option
causes the bar-code label on the cartridge to be presented
to the host interface as all or fewer characters, selected
from the left or right of the physical label.
Note: For partitioned libraries, you must enter the label
orientation for each partition (the “<partition>” field has
been added for this feature.
upsidedowndetect <on|off> Sets the upsidedowndetect option. On is the default
setting and allows the library to detect upside down SDLT
cartridges in mixed-media libraries. Off disables the
checking function.
TABLE B-2 CLI Commands for Tape Drive Configuration
drive all (firmware level 1022) Shows information for all tape drives
drive <addr> clean
(firmware level 1022)
Cleans the specified tape drive. A label may be specified
when prompted.
drive <addr> getconfig
drive 0,1,1,9 getconfig
Shows a specified tape drive's Fibre Channel or SCSI
configuration
drive <addr> gettime Shows a specified tape drive's time of day (TOD) clock
setting
drive <addr> info Shows a specified tape drive’s information
drive <addr> setconfig Sets a specified tape drive's Fibre Channel or SCSI
configuration
drive <addr> settime Sets a specified tape drive's time of day (TOD) clock
drive <addr> state Shows a specified tape drive’s operational state.
TABLE B-1 CLI Commands for Library Configuration (Continued)
To Next Page
Loading...
Need help?
General
