Log Sense
104 SL500: Interface Reference Manual • July 2008 Revision: F • 96122
0009h Library Humidity
Limits
Set when general conditions inside the library exceed
the humidity specifications.
C
000Ah Library Temperature
Limits
Set when general conditions inside the library exceed
the temperature specifications.
C
000Bh Library Voltage Limits Set when the voltage supply exceeds specifications. C
000Ch Library Stray Tape Set when a cartridge was left in a drive because of a
previous hardware fault.
C
000Dh Library Pick Retry Set if the hand requires more than one try to pick a
cartridge from a cell or drive.
W
000Eh Library Place Retry Set if the hand requires more than one try to place a
cartridge into a cell.
W
000Fh Library Load Retry Set if the hand requires more than one try to place a
cartridge into a drive.
W
0010h Library Door Set if the door has been opened, and no library
motions are allowed. When the door is closed, the
library will IPL.
C
0011h Library Mail slot Set when the mail slot (cartridge access port) switch
has failed.
C
0012h Library Magazine Set when the library needs the magazine. C
0013h Library Security Set when the security was compromised. W
0014h Library Security Mode Set when the security mode was changed. I
0015h Library Offline Set when the library has been placed into maintenance
mode from the operator panel or a Web interface.
I
0016h Library Drive Offline Set when a drive was taken offline. I
0017h Library Scan Retry Set when more than one attempt is required to read a
bar code. The problem is caused when only part of the
bar code can be read. The library supports cartridges
with no labels.
W
0018h Library Inventory Set when the library detected an inconsistency in its
inventory.
C
0019h Library Illegal
Operation
Set when an unsupported SCSI command is sent to the
library. This is not a corrupted command detected for
flag 6.
W
001Bh Cooling Fan failure Set when the library cooling fan has failed W
001Ch Power Supply Set when a redundant power supply has failed inside
the library. Check the library users manual for
instructions on replacing the failed power supply.
W
001Dh Power Consumption Set when the library power consumption is outside the
specified range.
W
0020h Unreadable Bar Code
Labels
The library was unable to read the bar code on a
cartridge.
I
TABLE 6-18 TapeAlert Flags (Continued)
To Next Page
Loading...
Need help?
General
