4-22 Sun Fire X2100 Server User Guide • April 2007
4.5.6 DVD Drive Assembly
The following procedure describes how to replace the DVD drive assembly. If you
are not replacing a DVD drive, go straight to Section 4.5.6.2, “Installing the DVD
Drive Assembly” on page 4-23.
4.5.6.1 Removing the DVD Drive Assembly
Follow these steps to remove the DVD drive assembly:
1. Power off the system and remove the cover as described in Section 4.3, “Powering
Off the Server and Removing the Cover” on page 4-3.
2. Unfasten the drive ribbon cable from the SATA backplane.
Caution – Use care. The small flat cables are extremely fragile.
FIGURE 4-17 Removing the DVD Drive Assembly
To Next Page
Loading...
