Chapter 5 Overview of the XSCF Shell 5-11
5.2.4 Operation For Connecting Via the XSCF-LAN
(Telnet)
This section describes how to log in to XSCF via an XSCF-LAN (telnet) connection.
1. Enter the IP address or host name of XSCF and port number 23, and use telnet
via XSCF-LAN.
2. Enter a user account and password from the XSCF console.
3. Enter XSCF commands at the shell prompt (XSCF>) that is displayed after you
login to XSCF.
4. The following is a login example:
5.3 View Server Status and Control
Commands
This section describes the typical XSCF Shell commands that can be used to display
the server status, operate the server, and control the server. For details on the
commands, see the man page or the XSCF Reference Manual. For XSCF setup
commands, see Chapter 2.
â– showenvironment
â– showlocator/setlocator
â– showconsolepath
â– fmadm / fmdump / fmstat
â– showdomainstatus
â– reset / poweron / poweroff
â– sendbreak
showenvironment
The showenvironment(8) command displays the values of all sensors in the server.
By finding out the intake temperature, humidity, voltage, and fan rotation speed in
the server, the system administrator can check for errors in the system environment.
login:jsmith
Password:xxxxxxxx
XSCF>
To Next Page
Loading...
Need help?
General
