B-10 SPARC Enterprise Mx000 Servers XSCF User’s Guide • August 2009
B.4.5 IPL Log
Using the showlogs(8) Command to Reference IPL Logs
After the domain power supply is turned on, console messages are output to the
domain console until the running status is set. These console messages are collected
by the XSCF firmware in an IPL log. In some cases, IPL logs may be called IPL
message logs. Specify the ipl option on the XSCF Shell and perform the showlogs(8)
command to reference IPL logs. The following items are displayed:
■ Domain ID (DomainID)
■ Time at which each IPL log was collected (Date). This is indicated in local time.
■ IPL message (Message)
B.5 Audit Log
This section explains how to reference the audit logs by using the viewaudit(8)
command. For details of each log option, audit class, and audit event of
viewaudit(8), see the XSCF Reference Manual or the main page. See
TABLE 8-3 for the
size and generation number of each log.
Using the viewaudit(8) Command to Confirm the Audit Trail
● Perform the viewaudit(8) command on the XSCF Shell.
To Next Page
Loading...
