Chapter 2 Setting Up XSCF 2-51
2. Use the setntp(8) command to change a stratum value.
When you use the setntp(8) command to specify the stratum value, execute the
rebootxscf(8) command to apply the specified configuration and reset the XSCF.
3. Use the showntp(8) command to confirm the stratum value change.
Setting the Domain Time to the XSCF Time
■ Command operation
1. Use the showdate(8) command to display the XSCF time.
2. Use the showdateoffset(8) command to confirm the difference the XSCF time
with each domain time.
3. Use the poweroff(8) command to turn off power to all domains.
<Example> Set 7 as stratum value for XSCF network.
XSCF> setntp -c stratum -i 7
Please reset the XSCF by rebootxscf to apply the ntp settings.
XSCF> showntp -s
stratum : 7
XSCF> showdate
Mon Jan 23 14:53:00 JST 2006
XSCF> showdateoffset -a
DID Domain Date Offset
00 128 sec
01 0 sec
02 -1024 sec
03 -9999999 sec
To Next Page
Loading...
