Chapter 1 XSCF Overview 1-21
In the M8000/M9000 servers, a basic cabinet and an expansion cabinet contain one
DVD drive/tape drive unit respectively, and they are assigned to a single operating
domain of each cabinet. The DVD drive/tape drive unit can be used by assigning it
to a specific card port on the I/O unit. To assign a different port, specify the unit by
using the XSCF Shell. For details on this DVD drive/tape drive unit setting, see
Chapter 2.
Note – Do not use the CD_RW/DVD-RW drive unit and the tape drive unit at the
same time.
1.4 XSCF User Interfaces
This section describes the XSCF user interfaces.
1. XSCF Shell (Ethernet Connection):
A set of XSCF Shell commands you can use from a PC or a terminal connected to the
XSCF over an XSCF-LAN Ethernet connection using SSH or telnet. Also, you can
switch to domain console.
2. XSCF Shell (Serial Connection):
A set of XSCF Shell commands you can use from a PC or terminal directly connected
to the XSCF by a serial cable. Also, you can switch to domain console.
3. XSCF Web:
A set of browser user interface (BUI) operations you can use from a web browser
connected to the XSCF over the XSCF-LAN Ethernet.
4. XSCF SNMP Agent functions:
SNMP manager commands used to monitor the operation of the server's network
functions.
5. XSCF mail functions:
Sends email reports of the system status.
For details about connecting to XSCF consoles, see Chapter 3.
To Next Page
Loading...
Need help?
General
