9-18 SPARC Enterprise Mx000 Servers XSCF User’s Guide • August 2009
TABLE 9-11 lists the functions for setting the XSCF time. Select [Settings]-[Time] in the
Menu tree.
TABLE 9-12 lists the functions for setting the SSH/telnet. Select
[Settings]-[SSH/Telnet] in the Menu tree.
Note – The host key generation, the user public key registration/deletion, and the
timeout period setting for XSCF Shell are not supported by XSCF Web. Set these
functions by using XSCF Shell.
TABLE 9-11 Time Settings
Function Remarks
System time display and setting Displays and sets the current system time.
This function is equivalent to the
applynetwork(8) and rebootxscf(8) commands.
After setting, the XSCF is reset
NTP server display and configuration Displays and sets the time zone and Daylight
Saving Time.
These function are equivalent to the showntp(8)
and setntp(8) commands. Reset XSCF to complete
the settings.
TABLE 9-12 SSH/telnet Settings
Function Remarks
SSH Enabling and disabling Displays and sets the enabling/disabling the SSH.
These function are equivalent to the showssh(8)
and setssh(8) commands.
After enabling SSH, the XSCF reset is required.
Access control from domain to the SSH Specifies whether or not to permit access from
domain to the SSH via the DSCP.
These function are equivalent to the showssh(8)
and setssh(8) commands.
After setting the SSH access control, the XSCF reset
is required.
telnet Enabling and disabling Displays and sets the enabling/disabling of telnet.
These function are equivalent to the
showtelnet(8) and settelnet(8) commands.
After disabling telnet, XSCF reset is required.
To Next Page
Loading...
