5-8 SPARC Enterprise Mx000 Servers XSCF User’s Guide • August 2009
5.2.1 Before Logging In
Note the following before attempting to log in:
â– For details on how to create, add, and delete user accounts, see Chapter 2.
â– After login, if the shell has not been accessed for a certain period, XSCF
automatically terminates the shell. The default timeout period is 10 minutes. The
timeout period can be specified. For details on specifying the timeout period, see
Chapter 2.
â– In one domain, only one user can use the RW console (write-enabled console).
While one user is using the RW console, another user cannot start another RW
console in the same domain. For details on console connection, see Chapter 3.
â– When a login fails, see Appendix D.
Note – In this manual, the window of the XSCF Shell terminal is called the XSCF
console.
5.2.2 Operation From a Terminal Connected to the
Serial Port
This section describes how to log in from a terminal connected to the serial port.
1. After the terminal is connected to the serial port, press the Enter key on the
terminal.
2. Enter a user account and password when prompted by XSCF.
3. Enter XSCF commands at the shell prompt (XSCF>) that is displayed after login
to XSCF.
The following is a login example:
login: jsmith
Password: xxxxxxxx
XSCF>
To Next Page
Loading...
Need help?
General
