3-10 SPARC Enterprise Mx000 Servers XSCF User’s Guide • August 2009
b. Follow Step a to Step c in the above “Connecting the XSCF Shell terminal.”
c. Perform the console(8) command.
d. Confirm the change into the specified domain console.
Note – In this system, you can use SSH to access from domain to XSCF via DSCP.
And you can use the setssh(8) command to disable the SSH access from domain to
XSCF. For details on the SSH access control via DSCP, see Section 2.2.5, “SSH/Telnet
Administration” on page 2-53.
3.1.6 Connecting to XSCF Using Telnet via the LAN
Port
The procedure described below assumes that telnet is enabled in the SSH/telnet
settings of XSCF, as described in Chapter 2. For details on cable connections between
the server and a LAN and the connection between a PC and workstation, see the
Installation Guide for your server.
The following is the procedure for connecting to a terminal using telnet via the
XSCF-LAN port.
1. Confirm that the LAN cable is inserted into the XSCF-LAN port connector on
the front of the XSCF Unit, or confirm that the PC and workstation to be used
are correctly connected.
2. On the PC or workstation to be used, use one of the following procedures:
■ Connecting the XSCF Shell terminal
To Next Page
Loading...
Need help?
General
