1A-31 Engine General Information and Diagnosis:
P0105-L for IAP sensor (Use of SDS)
Step Action Yes No
1 1) Turn the ignition switch OFF.
2) Remove the front fender. Refer to “Front Side Exterior
Parts Removal and Installation in Section 9D (Page 9D-
6)”.
3) Check the IAP sensor coupler for loose or poor contacts.
If OK, then check the IAP sensor lead wire continuity.
4) Disconnect the IAP sensor coupler.
5) Check the continuity between the G/B wire and ground.
Also, check the continuity between the G/B wire and B/
Br wire. If the sound is not heard from the tester, the
circuit condition is OK.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
Go to Step 2. R and G/B wire open, G/
B wire shorted to the
ground.
I831G1110026-01
(A)
I831G1110029-01
To Next Page
Loading...
