Power Assisted Steering System: 6C-24
SDS Check (LT-A750XP/ZK9)
B931G46304006
Using SDS, take the sample of data from the new vehicle and at the time of periodic maintenance at your dealer.
Save the data in the computer or by printing and filing the hard copies. The saved or filed data are useful for
troubleshooting as they can be compared periodically with changes over time or failure conditions of the vehicle.
For example, when a vehicle is brought in for service but the troubleshooting is difficult, comparison with the normal
data that have been saved or filed can allow the specific EPS failure to be determined.
1) Remove the seat. Refer to “Seat Removal and Installation in Section 9D in related manual”.
2) Set up the SDS tool. (Refer to “SDS operation manual for further details.)
NOTE
• Before taking the sample of data, check and clear the Past DTC. Refer to “DTC (Diagnostic Trouble
Code) Deleting (LT-A750XP/ZK9) (Page 6C-21)”.
• A number of different data under a fixed condition as shown should be saved or filed as sample.
Special tool
: 09904–41010 (SUZUKI Diagnostic system set)
: 99565–01010–020 (CD-ROM Ver.20)
DATA sampled from EPS system
Handlebars is
center position
Check the torque when turning
Check the torque when turning
the handlebars right turn
the handlebars right turn
Check the torque when turning
Check the torque when turning
the handlebars left turn
Check the motor terminal voltage XX V
Check the motor terminal voltage XX V
Handlebars is
center position
Check the torque when turning
the handlebars right turn
Check the torque when turning
the handlebars left turn
There is no display 0V and less
There is no display 0V and less
There is no display 0V and less
Check the motor terminal voltage XX V
I931H1630104-03
To Next Page
Loading...
