Suzuki LT-A750X/P - Fuel Tank Pressure Control (FTPC) Valve Removal and Installation

Fuel System: 1G-12
• Install the fuel delivery pipe assembly (5) to the
throttle body assembly.
CAUTION
!
Never turn the fuel injector while installing it.
• Tighten the fuel delivery pipe mounting screws to the
specified torque.
Tightening torque
Fuel delivery pipe mounting screw (a): 5 N·m (0.5
kgf-m, 3.5 lb-ft)
Fuel Tank Pressure Control (FTPC) Valve
Removal and Installation
B831G21706016
Removal
1) Remove the rear carrier. Refer to “Rear Carrier
Removal and Installation in Section 9E (Page 9E-5)”.
2) Remove the seat. Refer to “Seat Removal and
Installation in Section 9D (Page 9D-11)”.
3) Remove the side covers, left and right. Refer to
“Front Side Exterior Parts Removal and Installation
in Section 9D (Page 9D-6)”.
4) Remove the engine side cover. Refer to “Rear Side
Exterior Parts Removal and Installation in Section
9D (Page 9D-9)”.
5) Remove the mad guard mounting fasteners (1) and
screws (2).
6) Remove the fuel tank cap (3).
CAUTION
!
To prevent the fuel tank from contamination
with foreign particles, blind opening.
(a)
5
I831G1170028-01
1
2
I831G1170029-01
1
2
I831G1170030-01
3
I831G1170031-01