1J-12 Charging System:
Battery Removal and Installation
B831G21A06008
Removal
1) Remove the seat. Refer to “Seat Removal and
Installation in Section 9D (Page 9D-11)”.
2) Remove the battery stay (1).
3) Disconnect the battery (–) lead wire (2).
4) Disconnect the battery (+) lead wire (3).
NOTE
Be sure to disconnect the battery (–) lead
wire (2) first, then disconnect the battery (+)
lead wire (3).
5) Remove the battery (4).
Installation
Install the battery in the reverse order of removal.
Pay attention to following point:
CAUTION
!
Never use anything except the specified
battery.
• Tighten the battery lead wire mounting bolts securely.
Battery Visual Inspection
B831G21A06009
Inspect the battery in the following procedures:
1) Remove the seat. Refer to “Seat Removal and
Installation in Section 9D (Page 9D-11)”.
2) Visually inspect the surface of the battery container.
If any signs of cracking or electrolyte leakage from
the sides of the battery have occurred, replace the
battery with a new one.
If the battery terminals are found to be coated with
rust or an acidic white powdery substance, clean the
battery terminals with sandpaper.
3) Install the seat.
Specifications
Service Data
B831G21A07001
Battery
CAUTION
!
Never use anything except the specified battery.
Generator
1
I831G11A0028-02
3
4
2
I831G11A0029-02
Item Specification Note
Type designation YTX20CH-BS
Capacity 12 V, 64.8 kC (18 Ah)/10 HR
Item Specification Note
Generator coil resistance 0.4 – 1.0 Ω
Generator maximum output Approx. 400 W at 5 000 r/min
Generator no-load voltage
(When engine is cold)
75 V (AC) and more at 5 000 r/min
Regulated voltage 13.5 – 15.5 V at 5 000 r/min
To Next Page
Loading...
