Suzuki LT-A750X/P - Water Pump Disassembly and Assembly

Engine Cooling System: 1F-14
Installation
Install the water pump in the reverse order of removal.
Pay attention to the following points:
• Apply grease to the O-rings.
CAUTION
!
Replace the O-rings with the new ones.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Set the water pump driven gear (1) to the water pump
drive gear (2) and install the water pump assembly
(3).
• Tighten the water pump mounting bolts (4) to the
specified torque.
Tightening torque
Water pump mounting bolt (a): 10 N·m (1.0 kgf-
m, 7.0 lb-ft)
• Connect the water hoses securely. Refer to “Water
Hose Routing Diagram (Page 1F-3)”.
• Pour engine oil and coolant. Refer to “Engine Oil and
Filter Replacement in Section 0B (Page 0B-10)” and
“Cooling System Inspection in Section 0B (Page 0B-
15)”.
• Bleed air from the cooling circuit. Refer to “Front
Differential Gear Oil Inspection in Section 0B
(Page 0B-12)”.
Water Pump Disassembly and Assembly
B831G21606018
Refer to “Water Pump Removal and Installation
(Page 1F-13)”.
Disassembly
1) Remove the O-rings (1), snap ring (2), washer (3)
and water pump driven gear (4).
2) Remove the water pump cover (5).
3) Remove the O-ring (6).
1
2
3
I831G1160035-01
(a)
4
I831G1160036-01
1
2
3
4
I831G1160037-02
5
I831G1160038-01
6
I831G1160039-01