Suzuki LT-A750X/P - Steering Shaft Removal and Installation

Steering / Handlebar: 6B-6
Steering Shaft Removal and Installation
B831G26206005
Removal
1) Remove the front wheels. Refer to “Front / Rear
Wheel Removal and Installation in Section 2D
(Page 2D-2)”.
2) Remove the front fender. Refer to “Front Side
Exterior Parts Removal and Installation in Section
9D (Page 9D-6)”.
3) Remove the handlebars. Refer to “Handlebars
Removal and Installation (Page 6B-3)”.
4) Remove the auxiliary headlight. Refer to “Auxiliary
Headlight Removal and Installation in Section 9B
(Page 9B-3)”.
5) Remove the handlebar holder (1).
6) Disconnect the tie-rod ends. Refer to “Front Wheel
Hub / Steering Knuckle Removal and Installation in
Section 2B (Page 2B-4)”.
7) Remove the steering lower arm plate (2) by
removing cotter pin, nut and washer.
8) Remove the center cover.
9) Disconnect the brake hose (3) from the hose guide.
10) Remove the read wire clamps.
11) Remove the steering shaft plate (4).
12) Remove the steering shaft holders (5) and dust seal
(6).
13) Remove the steering shaft (7) from the vehicle.
14) Remove the dust seal (8) and O-ring (9).
1
I831G1620020-01
2
I831G1620021-01
I831G1620023-01
3
I831G1620024-03
4
I831G1620025-03
6
5
7
I831G1620026-03
9
8
I831G1620022-03