6B-7 Steering / Handlebar:
15) Remove the steering shaft bushing (10) and dust
seal (11) with the special tools and suitable socket
wrench.
Special tool
(A): 09924–84521 (Bearing installer set)
(B): 09930–30721 (Rotor remover)
Installation
Install the steering shaft in the reverse order of removal.
Pay attention to the following points:
• Install the steering shaft lower bushing (1) along with
dust seal (2) with the special tools.
Special tool
(A): 09924–84521 (Bearing installer set)
(B): 09913–70210 (Bearing installer set)
• Apply grease to the steering shaft lower bushing (1)
and dust seal (2).
: Grease 99000–25160 (Water resistance
grease)
• Apply grease to the dust seal (3) and O-ring (4).
CAUTION
!
The removed O-ring must be replaced with a
new one.
: Grease 99000–25160 (Water resistance
grease)
• Apply grease to the spline of steering shaft.
: Grease 99000–25160 (Water resistance
grease)
• Install the steering shaft.
• Apply grease to the steering shaft holder dust seal
before installing.
: Grease 99000–25160 (Water resistance
grease)
(A)
(B)
(A)
11
10
I831G1620027-04
(A)
(B)
1
2
I831G1620048-01
2
1
I831G1620029-02
4
3
I831G1620032-02
I831G1620033-01
I831G1620028-01
To Next Page
Loading...
