Steering / Handlebar: 6B-8
• Apply grease to the steering shaft holders before
installing the shaft holders.
: Grease 99000–25160 (Water resistance
grease)
CAUTION
!
To prevent the entry of dirt, the dust seal end
“A” must face rearward when installing the
dust seal to steering shaft.
• Install the steering shaft holder (5) and tighten the
mounting bolts (6) to the specified torque.
Tightening torque
Steering shaft holder bolt (a): 23 N·m (2.3 kgf-m,
16.5 lb-ft)
• After installed steering shaft plate, make sure that the
wiring harness, cables and brake hose routing are
properly. Refer to “Wiring Harness Routing Diagram in
Section 9A (Page 9A-4)”.
• When installing the steering arm plate, align the wide
spline “B” of steering shaft (7) with slit “C” of steering
arm plate (8).
• Apply a small quality thread lock to the thread part of
steering shaft.
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
• Tighten the steering shaft lower nut (9) to the specified
torque.
Tightening torque
Steering shaft lower nut (b): 162 N·m (16.2 kgf-m,
117.0 lb-ft)
• Install the cotter pin.
CAUTION
!
The removed cotter pin must be replaced
with a new one.
“A”
I831G1620030-02
(a)
6
5
I831G1620031-02
“B”
7
“C”
8
I831G1620034-02
(b)
9
I831G1620035-03
To Next Page
Loading...
