Suzuki LT-A750X/P - Clutch Housing Case Disassembly and Assembly

Automatic Transmission: 5A-19
Clutch Housing Case Disassembly and
Assembly
B831G25106012
Refer to “Clutch Shoe Removal and Installation
(Page 5A-16)”.
Disassembly
• Remove the clutch housing (1) from clutch housing
case.
• Remove the collar (2).
• Remove the oil seal (3) with the special tool.
Special tool
(A): 09913–50121 (Oil seal remover)
• Remove the retainers (4).
• Remove the bearing (5) with the special tool.
Special tool
(B): 09921–20240 (Bearing remover set)
NOTE
If there is no abnormal noise, the bearing
removal is not necessary.
Assembly
• Install the bearing (1) with the special tool.
Special tool
(A): 09913–70210 (Bearing installer set)
CAUTION
!
The removed bearing must be replaced with a
new one.
1
I831G1510074-01
2
I831G1510075-01
3
(A)
I831G1510076-01
4
I831G1510077-01
5
(B)
I831G1510078-01
1
(A)
I831G1510079-01