5A-18 Automatic Transmission:
• Apply molybdenum oil solution to the inside of the one
way clutch (4).
M/O: Molybdenum oil (MOLYBDENUM OIL
SOLUTION)
• Install the one way clutch (4) with facing the
“OUTSIDE” mark “A” outside.
• Install the dowel pins (5) and gasket (6).
CAUTION
!
Use a new gasket (6) to prevent oil leakage.
• Install the clutch housing case (7) and inlet belt
cooling duct connector (8) and tighten the bolts
diagonally.
• Install the V-belt inner cover (9).
CAUTION
!
If there are wear or damage, replace the
gaskets (10) with new ones.
CAUTION
!
Tighten the clutch inner cover bolts “A” first
and then other ones diagonally.
Tightening torque
V-belt inner cover bolt: 9 N·m (0.9 kgf-m, 6.5 lb-ft)
• Install the outlet belt cooling duct connector (11).
4
“A”
I831G1510071-02
4
“A”
I831G1510072-02
6
5
5
I831G1510114-02
7
8
I831G1510112-01
9
10
I831G1510113-01
11
9
“A”
“A”
I831G1510073-01
To Next Page
Loading...
