Automatic Transmission: 5A-17
9) Remove the washer (10).
10) Remove the clutch shoe (11) with the special tools.
Special tool
(C): 09930–30104 (Rotor remover slide
shaft)
(D): 09920–33540 (Clutch shoe remover)
Installation
Install the clutch shoe in the reverse order of removal.
Pay attention to the following points:
• Install the clutch shoe (1) and washer (2).
NOTE
Install the washer (2) as shown in the figure.
• Apply a small quantity of thread lock to the clutch
shoe nut (3).
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
• Install the clutch shoe nut (3).
NOTE
The clutch shoe nut (3) has left-hand threads.
• Tighten the clutch shoe nut (3) to the specified torque
with the special tools.
Tightening torque
Clutch shoe nut (a): 150 N·m (15.0 kgf-m, 108.5
lb-ft)
Special tool
(A): 09930–40113 (Rotor holder)
(B): 09930–40131 (Balancer drive sprocket
holder)
10
I831G1510065-02
11
(C)
(D)
I831G1510066-02
1
2
I831G1510067-01
“a”: Clutch shoe side “b”: Clutch shoe nut side
2
“a”
“b”
I831G1510068-01
3
I831G1510069-02
(A)
(B)
(a)
3
I831G1510070-01
To Next Page
Loading...
