Suzuki LT-A750X/P - Rear Suspension Lower Arm Bushing Removal and Installation

Rear Suspension: 2C-12
Rear Suspension Lower Arm Bushing Removal
and Installation
B931G22306013
Refer to “Rear Suspension Arm Upper / Lower Removal
and Installation (Page 2C-8)”.
Removal
1) Remove the following parts from the rear suspension
lower arm.
• Dust seal (1)
•Washer (2)
• Spacer (3)
2) Remove the rear suspension lower arm bushing (4)
along with inner dust seal (5) with the special tools.
Special tool
(A): 09923–73210 (Bearing remover)
: 09930–30104 (Rotor remover sliding shaft)
3) Remove the another inner dust seal (6) with the
special tool.
Special tool
(B): 09943–88211 (Bearing remover/
installer)
Installation
1) Install the rear lower arm bushings (1) and inner dust
seals (2) with the special tool and suitable socket.
NOTE
Position the bushings and dust seals by
referring to “Rear Suspension Assembly
Construction (Page 2C-2)”.
CAUTION
!
The removed bushings and dust seals must
be replaced with new ones.
Special tool
(A): 09941–34513 (Steering race installer)
3
2
3
2
3
1
1
I831G1230041-01
(A)
4
5
I831G1230043-03
(B)
6
I831G1230044-03
(A)
2
1
2
(A)
I831G1230045-01