Suzuki LT-A750X/P - Front Propeller Shaft Components; Front Propeller Shaft Removal and Installation

3D-14 Propeller Shafts:
Front Propeller Shaft Components
B831G23406010
Front Propeller Shaft Removal and Installation
B831G23406011
Refer to “Front Propeller Shaft Components (Page 3D-
14)” and “Front Drive (Differential) Construction in
Section 3B (Page 3B-3)”.
Removal
Remove the front drive (differential) assembly.
Refer to “Front Drive (Differential) Assembly Removal
and Installation in Section 3B (Page 3B-4)”.
1) Remove the front propeller shaft spring (1) and front
propeller shaft boot (2).
2) Loosen the boot clamp screw and remove the
universal joint boot (3).
NOTE
Apply oil to the removing direction of the
universal joint boot before removing.
3) Using a (–) screwdriver or the like into a notch of the
universal joint and remove the front propeller shaft
(4).
4) Remove the universal joint (5) from the joint portion
(at the engine side) with special tools.
Special tool
(A): 09923–74511 (Bearing remover)
(B): 09930–30104 (Rotor remover slide
shaft)
FWD
FWD
1
2
3
4
5
6
I831G1340045-04
1. Boot 5. Universal joint
2. Front propeller shaft spring 6. Boot
3. Front propeller shaft : Apply water resistance grease.
4. Circlip : Do not reuse.
1
2
3
I831G1340046-01
4
I831G1340047-01
5
(A)
(B)
I831G1340048-01