Propeller Shafts: 3D-15
Installation
CAUTION
!
The removed circlips must be replaced with
new ones.
1) Fit the front propeller shaft boot (1) and universal
joint boot (2) to the front propeller shaft groove.
2) Apply grease (approx. 4 grams) to the spline of
universal joint and spline of the front propeller shaft.
: Grease 99000–25160 (Water resistance
grease)
3) Connect the propeller shaft to the universal joint.
4) Apply grease (approx. 4 grams) to the spline.
: Grease 99000–25160 (Water resistance
grease)
5) Connect the universal joint to the joint portion (at the
engine side).
6) Attach the boot to the front drive collar and tighten
the boot clamp screw to the specified torque.
Tightening torque
Front propeller shaft boot clamp screw: 1.3 N·m
(0.13 kgf-m, 1.0 lb-ft)
7) Install the front propeller shaft spring.
8) Apply grease (approx. 4 grams) to the spline of front
propeller shaft and spring.
: Grease 99000–25160 (Water resistance
grease)
9) Install the front drive (differential) assembly. Refer to
“Front Drive (Differential) Assembly Removal and
Installation in Section 3B (Page 3B-4)”.
2
1
I831G1340049-02
I831G1340050-02
I831G1340051-01
I831G1340100-01
I831G1340052-01
To Next Page
Loading...
