Suzuki LT-A750X/P - Rear Suspension Knuckle Bushing Removal and Installation

2C-13 Rear Suspension:
2) Apply grease to the lip of inner dust seals, spacer (3)
and inside of dust seals (4).
: Grease 99000–25160 (Water resistance
grease or equivalent)
3) Install the spacer (3), dust seals (4) and washers (5)
to the rear suspension lower arm.
Rear Suspension Knuckle Bushing Removal
and Installation
B931G22306014
Refer to “Rear Wheel Hub / Suspension Knuckle
Removal and Installation (Page 2C-4)”.
Removal
1) Remove the following parts from the suspension
knuckle.
• Dust seal (1)
•Washer (2)
• Spacer (3)
2) Remove the suspension knuckle bushings along
with inner dust seals with the special tools.
Special tool
(A): 09923–73210 (Bearing remover)
(B): 09930–30104 (Rotor remover sliding
shaft)
Installation
1) Install the suspension knuckle bushing and inner
dust seal with the special tool and suitable socket
wrench.
NOTE
Position the bushing s and dust seals by
referring to “Rear Suspension Assembly
Construction (Page 2C-2)”.
CAUTION
!
The removed bushings and dust seals must
be replaced with new ones.
Special tool
(A): 09941–34513 (Steering race installer)
3
5
4
4
I831G1230046-02
1
2
1
2
3
2
2
3
I831G1230047-01
(A)
(B)
I831G1230048-03
(A)
I831G1230049-01