Suzuki LT-A750X/P - Transfer Related Bearing Inspection; Gear Position (GP) Switch Inspection; Gear Position (GP) Switch Removal and Installation

Transfer: 3C-13
Gearshift Fork Groove Width
Measure the gearshift fork groove width using the
vernier calipers.
Special tool
(A): 09900–20102 (Vernier calipers (1/20 mm,
200 mm))
Gearshift fork groove width
Standard (Reverse/Low & High): 5.5 – 5.6 mm (0.217
– 0.220 in)
Gearshift Fork Thickness
Measure the gearshift fork thickness using the vernier
calipers.
Special tool
(A): 09900–20102 (Vernier calipers (1/20 mm,
200 mm))
Gearshift fork thickness
Standard (Reverse/Low & High): 5.3 – 5.4 mm (0.209
– 0.213 in)
Transfer Related Bearing Inspection
B831G23306011
Refer to “Bearing Inspection in Section 1D (Page 1D-
61)”.
Gear Position (GP) Switch Inspection
B831G23306012
Refer to “Gear Position Switch Inspection in Section 1I
(Page 1I-9)”.
Gear Position (GP) Switch Removal and
Installation
B831G23306013
Removal
1) Turn the ignition switch OFF.
2) Remove the left and right side cover. Refer to “Front
Side Exterior Parts Removal and Installation in
Section 9D (Page 9D-6)”.
3) Remove the drive V-belt inner cover. Refer to “Clutch
Shoe Removal and Installation in Section 5A
(Page 5A-16)”.
4) Remove the clamp (1) and disconnect the gear
position switch coupler (2).
5) Disconnect the clamp and remove the gear position
switch (3).
(A)
I649G1520057-03
(A)
I649G1520058-03
1
2
I831G1330044-01
3
I831G1330045-01