Suzuki LT-A750X/P - Rear Brake Disassembly and Assembly

Rear Brakes: 4C-3
• Install the return spring (3) and lining indicator (4).
NOTE
Align the boss of lining indicator (4) with
wide spline on the brake cam shaft.
• Install the rear brake cam lever (5) to the rear brake
cam shaft.
NOTE
When installing the brake cam lever, align the
punched mark “D” with “E”.
• Tighten the cam lever nut (6) to the specified torque.
Tightening torque
Rear brake cam lever nut (b): 11 N·m (1.1 kgf-m,
8.0 lb-ft)
• Install the final gear assembly to the vehicle. Refer to
“Final Gear Assembly Removal and Installation in
Section 3B (Page 3B-23)”.
Rear Brake Disassembly and Assembly
B831G24306005
Refer to “Rear Brake Assembly Removal and Installation
(Page 4C-2)”.
Disassembly
1) Remove the gasket (1) and dowel pins (2).
2) Remove the rear brake steel plates (3) along with
the friction plates (4).
3) Remove the rear brake pressure plate (5) and balls.
3
4
I831G1430008-01
“E”
“D”
5
(b)
6
I831G1430009-02
1
2
2
I831G1430010-02
3
4
I831G1430011-01
5
I831G1430012-01