1D-33 Engine Mechanical:
• Apply grease to the O-ring of the intake pipe.
CAUTION
!
Replace the O-ring with new ones.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Apply a small quantity of thread lock to the intake pipe
mounting bolts and tighten them to the specified
torque.
NOTE
Make sure that the “UP” mark faces up.
Tightening torque
Intake pipe bolt (b): 9 N·m (0.9 kgf-m, 6.5 lb-ft)
: Thread lock cement 99000–32050
(THREAD LOCK CEMENT 1342 or equivalent)
• Apply thread lock to the water bypass union (2) and
tighten it to the specified torque.
Tightening torque
Water bypass union (c): 12 N·m (1.2 kgf-m, 8.5 lb-
ft)
: Thread lock cement 99000–32050
(THREAD LOCK CEMENT 1342 or equivalent)
• Install the valve spring seat.
• Apply engine oil to the oil seal (2), and press-fit it into
position.
CAUTION
!
Do not reuse the removed oil seal.
I831G1140156-01
(b)
I831G1140157-02
(c)
2
I831G1140158-04
2
I831G1140159-05
To Next Page
Loading...
