Engine Mechanical: 1D-64
Installation
CAUTION
!
The removed bearings and oil seals must be
replaced with new ones.
Generator cover
1) Install the oil seals (1) with suitable tool.
2) Install the each bearing (2) with a special tool.
CAUTION
!
Use the special tool suitable size for each
bearing to prevent damage.
Special tool
(A): 09913–70210 (Bearing installer set)
3) Install the snap rings (3).
CAUTION
!
The removed snap rings must be replaced
with new ones.
4) Apply grease to O-ring and install the speed sensor
(4).
CAUTION
!
Replace the O-ring with a new one.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
5) Tighten the bolt to the specified torque.
Tightening torque
Speed sensor bolt (a): 10 N·m (1.0 kgf-m, 7.0 lb-
ft)
6) Install the removed parts. Refer to “Generator
Removal and Installation in Section 1J (Page 1J-4)”.
1
1
I831G1140316-01
I831G1140317-02
3
I831G1140325-01
4
(a)
I831G1140318-01
To Next Page
Loading...
