Engine Lubrication System: 1E-6
7) Remove the snap ring (7) and oil pump driven gear
(8).
Special tool
: 09900–06107 (Snap ring pliers)
8) Remove the pin (9), washer (10) and oil pump (11).
Installation
Install the oil pump in the reverse order of removal. Pay
attention to the following points:
• Apply thread lock to the oil pump bolts.
: Thread lock cement 99000–32050
(THREAD LOCK CEMENT 1342 or equivalent)
• Install the new snap ring (1).
Special tool
: 09900–06107 (Snap ring pliers)
• Install the oil pump drive gear (2) with chain.
NOTE
The flange side of the oil pump drive gear (2)
inside.
• Apply thread lock super to the oil pump drive gear bolt
(3).
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
7
8
9
10
11
I831G1150014-01
I831G1150015-02
2. Oil pump drive gear
2
1
I831G1150020-02
2
OUTSIDE INSIDE
I831G1150016-07
3
I831G1150017-02
To Next Page
Loading...
