Charging System: 1J-5
8) Disconnect the gearshift lever arm (3) and speed
sensor coupler (4).
9) Disconnect the CKP sensor coupler (5) and
generator coupler (6).
10) Remove the starter cup nut with a suitable bar.
11) Remove the starter cup (7).
12) Remove the generator cover (8).
13) Remove the gasket (9) and dowel pins.
14) Hold the generator rotor with a 41 mm offset wrench.
15) Remove the generator rotor nut.
16) Install the special tool to the crankshaft end.
Special tool
(A): 09930–31921 (Rotor remover)
3
4
I831G11A0015-01
5
6
I831G11A0006-02
7
I831G11A0005-02
8
I831G11A0008-03
9
I831G11A0009-01
I831G11A0010-01
(A)
I831G11A0011-01
To Next Page
Loading...
