2B-5 Front Suspension:
8) Disengage the tie-rod end (8) with the special tool.
WARNING
!
When using the tie-rod end remover, keep
clear of the tie-rod end because it may come
loose with some force and could strike you.
Special tool
(A): 09942–72410 (Tie rod end remover)
9) Remove the cotter pins, knuckle end nuts and
washers.
10) Remove the steering knuckle (11) with a
commercially available bearing joint remover.
11) Remove the steering knuckle (11).
Installation
Install the steering knuckle in the reverse order of
removal. Pay attention to the following points:
• Apply grease to the lip of inner dust seal.
: Grease 99000–25160 (Water resistance
grease)
• Install the washer (1) and lock washer (2) and tighten
the knuckle end nuts (3) to the specified torque.
Tightening torque
Steering knuckle end nut (a): 29 N·m (2.9 kgf-m,
21.0 lb-ft)
8
(A)
I831G1220012-02
I831G1220013-02
11
11
I831G1220014-02
11
I831G1220015-02
I831G1220016-01
1
2
1
2
(a)
3
(a)
3
I831G1220017-01
To Next Page
Loading...
