2C-5 Rear Suspension:
2) Remove the rear wheel assembly. Refer to “Front /
Rear Wheel Removal and Installation in Section 2D
(Page 2D-2)”.
CAUTION
!
Make sure that the vehicle is supported
securely.
3) Remove the hub nut (3), washer (4) and rear wheel
hub (5).
4) Remove the suspension knuckle upper and lower
bolts and nuts.
5) Remove the rear suspension knuckle (6).
Installation
• Apply grease to the lip of outer dust seal.
: Grease 99000–25160 (Water resistance
grease or equivalent)
• Install the rear wheel hub (1) to the rear suspension
knuckle (2).
• Apply grease to the lip of outer dust seal and rear
wheel hub spline.
: Grease 99000–25160 (Water resistance
grease or equivalent)
• Tighten the rear knuckle nuts (3) to the specified
torque.
Tightening torque
Rear knuckle end nut (Upper and Lower) (a): 60
N·m (6.0 kgf-m, 43.5 lbf-ft)
• Install the washer (4) and hub nut (5).
NOTE
The conical side of washer (4) faces outside.
Refer to “Rear Suspension Assembly
Construction (Page 2C-2)”.
3
5
4
I831G1230008-01
6
I831G1230009-01
1
2
I831G1230066-01
I831G1230067-01
(a)
3
I831G1230068-01
4
5
I831G1230013-03
To Next Page
Loading...
