2C-7 Rear Suspension:
4) Remove the hub bearing (4) using the hydraulic
press and special tool.
Special tool
(B): 09913–70210 (Bearing installer set)
Installation
Install the hub bearing in the reverse order of removal.
Pay attention to the following points:
• Install the hub bearing (1) using the hydraulic press
and special tool.
CAUTION
!
Never reuse wheel hub bearing.
NOTE
The sealed side “A” of hub bearing (1) faces
inside.
Special tool
(A): 09913–75520 (Bearing installer)
• Install the snap ring (2) with the special tool.
CAUTION
!
Never reuse snap ring (2).
Special tool
: 09900–06108 (Snap ring pliers)
• Install a new inner dust seal (3) using a suitable size
socket wrench.
CAUTION
!
Replace the inner dust seal (3) with a new
one.
• Apply grease to the lip of inner dust seal (3).
: Grease 99000–25160 (Water resistance
grease or equivalent)
• Install a new outer dust seal (4) using a suitable size
socket wrench.
CAUTION
!
Replace the outer dust seal (4) with a new
one.
(B)
4
I831G1230064-02
1
“A”
I831G1230019-01
(A)
1
I831G1230020-01
2
I831G1230021-01
3
I831G1230022-01
To Next Page
Loading...
