Suzuki LT-A750X/P - Page 368

3B-8 Differential:
18) Remove the pinion gear pilot bearing with the special
tools.
NOTE
If there is no abnormal noise, the bearing
removal is not necessary.
Special tool
(E): 09921–20240 (Bearing remover set)
(F): 09944–66010 (Bearing installer)
(G): 09924–84521 (Bearing installer set)
19) Remove the front drive (differential) gear bearing
with the special tool, as shown in the figure.
NOTE
If there is no abnormal noise, the bearing
removal is not necessary.
Special tool
(D): 09913–60910 (Bearing remover)
Assembly
CAUTION
!
The removed oil seals, snap rings and
bearings must be replaced with new ones.
1) Install the bearings (1) to the front drive (differential)
gear assembly with the special tool.
Special tool
(A): 09913–70210 (Bearing installer set)
2) Install the pinion gear pilot bearing (2) into the front
drive (differential) gear case with the special tool.
Special tool
(A): 09913–70210 (Bearing installer set)
3) Install the pinion gear bearing (3) onto the gear shaft
with the special tool.
Special tool
(A): 09913–70210 (Bearing installer set)
(E)
(F)
(G)
I831G1320023-02
(D)
(D)
I831G1320024-01
(A)
(A)
1
1
I831G1320025-01
2
(A)
I831G1320026-01
3
(A)
I831G1320027-01