Propeller Shafts: 3D-3
3) Remove the O-ring (6).
4) Remove the oil seal (7) with the special tool.
Special tool
(A): 09913–50121 (Oil seal remover)
5) Remove the snap ring (8) and washer (9).
Special tool
: 09900–06108 (Snap ring pliers)
6) Remove the front output shaft bearing (front) with the
special tool.
NOTE
If there is no abnormal noise, the bearing
removed is not necessary.
Special tool
(B): 09921–20240 (Bearing remover set)
7) Remove the front output shaft bearing (rear) with the
special tool.
NOTE
If there is no abnormal noise, the bearing
removed is not necessary.
Special tool
(C): 09923–74511 (Bearing remover)
(D): 09930–30104 (Rotor remover slide
shaft)
6
I831G1340007-02
(A)
7
I831G1340008-01
8
9
I831G1340009-01
(B)
I831G1340010-01
(C)
(D)
I831G1340011-01
To Next Page
Loading...
