Propeller Shafts: 3D-7
4) Remove the rear output shaft (1).
5) Remove the C-ring (2).
6) Remove the drive shaft, counter shaft assembly and
reverse idle gear. Refer to “Transfer Removal and
Installation in Section 3C (Page 3C-3)”.
7) Unlock the drive bevel gear nut with a chisel.
8) Hold the transfer output driving gear with the special
tool and remove the drive bevel gear nut.
Special tool
(A): 09920–53740 (Clutch sleeve hub
holder)
9) Remove the washer (3), drive bevel gear (4) and
shim (5).
Installation
Install the rear output shaft in the reverse order of
removal. Pay attention to the following points:
• Hold the transfer output driven gear with the special
tool and tighten the drive bevel gear nut to the
specified torque.
CAUTION
!
The removed drive bevel gear nut must be
replaced with a new one.
Special tool
(A): 09920–53740 (Clutch sleeve hub holder)
Tightening torque
Rear output shaft drive bevel gear nut (a): 100
N·m (10.0 kgf-m, 72.5 lb-ft)
• Lock the drive bevel gear nut with a center punch.
1
I831G1340023-01
2
I831G1340090-01
(A)
I831G1340024-01
3
4
5
I831G1340026-02
(a)
(A)
I831G1340027-01
To Next Page
Loading...
