3D-18 Propeller Shafts:
4) Remove the rear propeller shaft spring (3).
5) Draw out the rear propeller shaft (4) horizontally.
6) Loosen the boot clamp screw and remove the rear
propeller shaft boot (5).
7) Remove the rear propeller shaft joint boot (6).
8) Remove the O-ring (7).
9) Remove the circlips from the universal joint.
10) Remove the bearings (8) by tapping with the special
tool and remove the universal joint and propeller
shaft yoke.
Special tool
(A): 09913–70210 (Bearing installer set)
11) Remove the circlips and joint (9).
3
I831G1340061-01
4
I831G1340062-01
5
I831G1340063-01
6
I831G1340064-01
7
I831G1340065-01
I831G1340066-03
8
8
8
(A)
I831G1340067-03
9
I831G1340068-04
To Next Page
Loading...
