4C-6 Rear Brakes:
• Install the oil seals (7) and (8) with the special tool.
Special tool
(A): 09913–70210 (Bearing installer set)
• Apply grease to the lip of cam shaft oil seal.
: Grease 99000–25160 (Water resistance
grease)
• Install the rear final drive gear shaft (9).
NOTE
If the rear final drive gear shaft not install
easily, lightly tap it using a plastic mallet.
• Install the rear brake cam shaft (10).
• Apply grease to the rear brake cam shaft.
: Grease 99000–25160 (Water resistance
grease)
• Install the rear propeller shaft coupling (11).
• Install the washer (12) and rear drive gear shaft nut
(13).
CAUTION
!
The removed nut (13) must be replaced with a
new one.
• Tighten the rear drive gear shaft nut (13) to the
specified torque with the special tool.
Special tool
(B): 09924–52420 (Secondary bevel gear
holder)
Tightening torque
Rear propeller shaft coupling nut (a): 100 N·m (
10.0 kgf-m, 72.5 lb-ft)
(A)
7
8
I831G1430024-05
I831G1430025-03
9
I831G1430026-04
10
I831G1430027-05
(B)
11
12
(a)
13
I831G1430028-06
To Next Page
Loading...
