5A-10 Automatic Transmission:
Assembly
1) Install the oil seals with the special tool.
Special tool
(A): 09913–70210 (Bearing installer set)
NOTE
The removed oil seals must be replaced with
new ones.
2) Apply grease to the lip of oil seals and inside grease
groove “A” of the movable drive face.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
CAUTION
!
• Wipe off any excess grease thoroughly.
• Take care not to apply grease to the
contact surface of the drive belt.
3) Assemble the rollers (1) to the movable drive face
(2).
4) Assemble the four dampers (3) to the movable drive
plate (4).
5) Assemble the movable plate (4) to the movable drive
face (3).
6) Apply grease to the inside groove of the spacer (5).
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
(A)
(A)
I831G1510028-01
“A”
I831G1510029-02
1
2
3
4
I831G1510030-01
3
4
I831G1510031-01
5
I831G1510032-02
To Next Page
Loading...
