Power Assisted Steering System: 6C-18
10 1) Turn the ignition switch OFF.
2) Short the mode select coupler terminals using the
special tool.
Special tool
(A): 09930–82710 (Mode select switch)
3) Check for continuity between terminal “A” and terminal
“B” at the coupler.
Special tool
(A): 09900–25008 (Multi circuit tester set)
Tester knob indication
Continuity ( )
EPS control unit coupler (Vehicle harness end)
Is there continuity between “A” and “B”?
Replace the EPS
control unit.
Inspect the wire
harness. (Faulty mode
select switch wire)
Step Action Yes No
(A)
(A)
I931G3630013-01
“A”
(A)
(ޓ)
“B”
(A)
(–)
I931G3630014-01
To Next Page
Loading...
