Power Assisted Steering System: 6C-52
• Install the cable guide (1) and tighten the bolts (2) to
the specified torque.
Tightening torque
EPS body assembly mounting bolt (a): 26 N·m (
2.6 kgf-m, 19.0 lbf-ft)
• Tighten the EPS body assembly mounting nuts (3) to
the specified torque.
Tightening torque
EPS body assembly mounting nut (b): 28 N·m (
2.8 kgf-m, 20.0 lbf-ft)
• Apply thread lock to the steering shaft bolt (4) and
tighten it to the specified torque.
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER “1303” or
equivalent)
Tightening torque
Steering shaft bolt (c): 26 N·m (2.6 kgf-m, 19.0 lbf-
ft)
• Install the front brake hose union (5) and throttle cable
(6) to the cable guide.
• Apply grease to the spline of the EPS body assembly.
: Grease 99000–25160 (Water resistance
grease or equivalent)
• Install the steering shaft plate (7) and tighten the
steering shaft upper nut to the specified torque.
CAUTION
!
• Never use an impact wrench when
tightening the steering shaft upper nut.
• Never exceed the specified torque to
prevent EPS body assembly damage.
Tightening torque
Steering shaft upper nut (d): 120 N·m (12.0 kgf-
m, 87.0 lbf-ft)
(a)
2
1
I931G3630059-02
(b)
3
I931G3630060-02
(c)
4
I931G3630061-03
5
6
I931G3630062-02
(d)
7
I931G3630072-01
To Next Page
Loading...
