Suzuki RV125 - Page 114

FUEL AND LUBRICATION SYSTEM 4-13
THROTTLE POSITION SENSOR POSITIONING
• Install the throttle position sensor with the flats on the throttle
shaft end securely engaged with the slot on the throttle posi-
tion sensor.
• Measure the resistance between the throttle position
sensor terminals as shown in the illustration.
$ Throttle position sensor resistance : Approx. 5 kΩ
ΩΩ
Ω
• Measure the resistance between the throttle position
sensor terminals as shown in the illustration.
• Fully open the throttle valve with the throttle lever.
• Position the throttle position sensor until resistance
is approx. 3.09 – 4.63 kΩ .
• When the resistance is within specification, tighten the
throttle position sensor mounting screws.
$ Throttle position sensor resistance :
Approx. 3.09 – 4.63 kΩ
ΩΩ
Ω
• After the assembly and installation on the engine have been
completed, perform the following adjustment.
* Engine idle speed ("2-8)
* Throttle cable play ("2-8)
Ω2
Ω1
Ω1
Ω1
Ω2
Ω2
Ω2
Ω2